An oven door gasket replacement is the fitting of a new seal round a Viking oven's cavity opening once the old one has been crushed, torn or pulled away from its fixings.
as used by Viking Appliance Repair Edmonds, (206) 210-3547
09 Costs · Edmonds
An oven door gasket replacement is the fitting of a new seal round a Viking oven's cavity opening once the old one has been crushed, torn or pulled away from its fixings.
as used by Viking Appliance Repair Edmonds, (206) 210-3547
In an Edmonds kitchen a failed seal shows up as slow, lopsided baking rather than a dead oven, so it is worth knowing early that this is quoted work with no published band behind it.
This work has no published band
$89 diagnosis, then a written quote
$89 diagnosis, credited The $89 diagnostic visit is one flat charge for the trip and the complete fault-finding, and it is credited in full against the repair you approve.
| What varies | How it moves the figure |
|---|---|
| The seal alone, or the door with it | A crushed gasket on a door that still hangs square is a smaller job than one where the hinges have dropped |
| How the seal is held on your model | Some seals clip into the frame and some into the door, and reaching those fixings is the part that varies |
| What is found behind the old seal | Soil burned into the frame, or a bent trim edge, is put right first or the new seal will not sit flat |
| Whether the door has to come off | A door removed to reach the fixings adds time, and it is refitted and checked square before the visit ends |
A gasket is renewed when a stretch of it has been crushed flat, torn, hardened where soil burned into it, or pulled out of its fixings at a corner. What to look for, and why the seal itself is never cleaned, is set out in the Care Handbook entry on the oven door gasket.
A seal and a sagging door give the same complaint: heat at one edge, one side of the tray browning first. Both are read cold, and hinge work is priced the same way on the oven door hinge repair page. On a built-in the door comes off and goes back in its column as part of Viking wall oven repair.
07In their words
Written up after the invoice and edited only for length. Names are shortened at the customers' request.
5.0 / 5799 reviews
The panel lit up and the cycle simply never started. A failed door switch, not the control board I had been told to expect. Running normally since.
The simmer setting kept dropping the flame out altogether on the left side. A lazy gas valve, not the control board a previous shop wanted to order. Half a morning, and it holds a low flame again.
Custom oak front, so I was braced for damage getting the machine out of the cabinets. It came out and went back with the reveals as they were. Standing water was a failed drain check valve.
A call to Viking Appliance Repair Edmonds reaches a person at any hour; the booking page lets you choose a visit window yourself, and a technician rings to confirm the appliance before the day. The diagnosis is a flat $89, deducted from any repair you approve.
Visits 8 am–8 pm daily · line staffed 24/7